This shows you the differences between two versions of the page.
Next revision | Previous revision Next revisionBoth sides next revision |
temperature_humidity_and_pressure_meter_to_mqtt_bme280 [08.01.2019 00:50] – created Pascal Suter | temperature_humidity_and_pressure_meter_to_mqtt_bme280 [08.01.2019 00:51] – [OpenMQTTGateway] Pascal Suter |
---|
first try was with the [[https://github.com/1technophile/OpenMQTTGateway|OpenMQTTGateway]] as i had the arduino IDE ready to go and the code configured and compiled from trying to set up an [[ble_mqtt_gateway]] which sadly did not work, probably due to a DOA module. however, read that article on setting up the OpenMQTTGateway software for flashing. for the BME280 to work you need to enable the ''ZsensorBME280'' in ''User_config.h'', the rest is identical. | first try was with the [[https://github.com/1technophile/OpenMQTTGateway|OpenMQTTGateway]] as i had the arduino IDE ready to go and the code configured and compiled from trying to set up an [[ble_mqtt_gateway]] which sadly did not work, probably due to a DOA module. however, read that article on setting up the OpenMQTTGateway software for flashing. for the BME280 to work you need to enable the ''ZsensorBME280'' in ''User_config.h'', the rest is identical. |
| |
the hardware wiring by default looks like this: | the [[https://github.com/1technophile/OpenMQTTGateway/wiki/ESP8266-I2C-Modules|hardware wiring]] by default looks like this: |
^ I2C Module ^ NodeMCU / ESP8266 ^ | ^ I2C Module ^ NodeMCU / ESP8266 ^ |
| Vcc |Vu (5V) | | | Vcc |Vu (5V) | |
|GND | GND | | |GND | GND | |
|SCL |D1| | |SCL |D1| |
|SDA| D2| | |SDA|D2| |
|ADD |N/C (Not Connected| | |ADD |N/C (Not Connected| |
| |