Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
workbee_cnc_router [22.06.2020 09:11] – Pascal Suter | workbee_cnc_router [09.08.2020 15:08] – [Workbee CNC Router] Pascal Suter | ||
---|---|---|---|
Line 55: | Line 55: | ||
|MDF|1/8 upcut 2-flute|spiralpocket | 7000 | 500 | no smoke| | |MDF|1/8 upcut 2-flute|spiralpocket | 7000 | 500 | no smoke| | ||
|Valchromat (Colored MDF, slightly harder than regular MDF)|6mm straight 2-flute | 7mm | 10'000 | 2000 mm/min | some vibrations but acceptable quality that only needs slight sanding on visible edges | | |Valchromat (Colored MDF, slightly harder than regular MDF)|6mm straight 2-flute | 7mm | 10'000 | 2000 mm/min | some vibrations but acceptable quality that only needs slight sanding on visible edges | | ||
+ | |Aluminum|1/ | ||
+ | |||
+ | ===== G-Code Sender ===== | ||
+ | my Workbee is using the GRBL firmware on a arduino together with a CNCshield on top of it. In order to send gcode to the arduino, a gcode-sender is used on a PC that is connected via USB. | ||
+ | |||
+ | currently i am using UGS (Univseral Gcode Sender) Platform edition. The reason why i chose this software is simple: i used it on my shapeoko and already kenw it. It seems though, that UGS crashes every now and then, leaving the machine stuck. i then need stop the job, disconnect from the arduino, reconnect and start over again. since the ardino still knows the machine position etc. I have a feeling this crash might happen on the UGS side. I therefore want to try different gcode senders in the near future. the two most interesting ones seem to be: | ||
+ | * [[https:// | ||
+ | * [[https:// | ||