Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
workbee_cnc_router [03.11.2019 19:44] – Pascal Suter | workbee_cnc_router [22.06.2020 09:17] – Pascal Suter | ||
---|---|---|---|
Line 52: | Line 52: | ||
|OSB|1/4 upcut|6mm | 19200 | 1700 mm/min | very rough cut, a little smoke every now and then | | |OSB|1/4 upcut|6mm | 19200 | 1700 mm/min | very rough cut, a little smoke every now and then | | ||
|OSB|1/4 upcut|3mm | 19200 | 3000 mm/min | much smoother, no smoke | | |OSB|1/4 upcut|3mm | 19200 | 3000 mm/min | much smoother, no smoke | | ||
+ | |MDF|1/8 upcut 2-flute|spiral ?? bore | 3000 | 500 | no smoke but vibrations | | ||
+ | |MDF|1/8 upcut 2-flute|spiralpocket | 7000 | 500 | no smoke| | ||
+ | |Valchromat (Colored MDF, slightly harder than regular MDF)|6mm straight 2-flute | 7mm | 10'000 | 2000 mm/min | some vibrations but acceptable quality that only needs slight sanding on visible edges | | ||
- | next: mdf: so far huge defelction | + | ===== G-Code Sender ===== |
+ | my Workbee is using the GRBL firmware on a arduino together with a CNCshield on top of it. In order to send gcode to the arduino, a gcode-sender is used on a PC that is connected via USB. | ||
+ | |||
+ | currently i am using UGS (Univseral Gcode Sender) Platform edition. The reason why i chose this software is simple: i used it on my shapeoko and already kenw it. It seems though, | ||
+ | * [[https:// | ||
+ | * [[https:// | ||