Differences

This shows you the differences between two versions of the page.

--- workbee_cnc_router [03.11.2019 19:44] – Pascal Suter
+++ workbee_cnc_router [22.06.2020 09:11] – Pascal Suter
@@ Line 52: / Line 52: @@
 |OSB|1/4 upcut|6mm | 19200 | 1700 mm/min | very rough cut, a little smoke every now and then |
 |OSB|1/4 upcut|3mm | 19200 | 3000 mm/min | much smoother, no smoke |
+|MDF|1/8 upcut 2-flute|spiral ?? bore | 3000 | 500 | no smoke but vibrations |
-next: mdf: so far huge defelction of machine at any speed that does not create smoke or even if it is slow enough to cause lots of smoke. found out that the machine's Z axis suddenly had lots of play, need to readjust the wheels and also clean out the bit.
+|MDF|1/8 upcut 2-flute|spiralpocket | 7000 | 500 | no smoke|
+|Valchromat (Colored MDF, slightly harder than regular MDF)|6mm straight 2-flute | 7mm | 10'000 | 2000 mm/min | some vibrations but acceptable quality that only needs slight sanding on visible edges |