Show pageOld revisionsBacklinksBack to top Old Revisions These are the older revisons of the current document. To revert to an old revision, select it from below, click Edit this page and save it. 23.02.2020 12:03 tevo_tarantula_i3_3d_printer – [Dead Stepper driver - workaround] Pascal Suter +1.3 KB (current) 16.02.2020 23:14 tevo_tarantula_i3_3d_printer – [Dead Stepper driver - workaround] Pascal Suter +45 B 16.02.2020 23:14 tevo_tarantula_i3_3d_printer – [Slicer Software and Settings] Pascal Suter +1.3 KB 16.02.2020 14:55 tevo_tarantula_i3_3d_printer – [Setting the Z Axis Sensor offset] Pascal Suter ±0 B 15.12.2018 15:56 tevo_tarantula_i3_3d_printer – [Slicer Software and Settings] Pascal Suter +68 B 09.12.2018 17:11 tevo_tarantula_i3_3d_printer – [Settings] Pascal Suter +205 B 09.12.2018 16:52 tevo_tarantula_i3_3d_printer – [Setting the Z Axis Sensor offset] Pascal Suter -1.2 KB 20.03.2018 23:49 tevo_tarantula_i3_3d_printer – [Z axis stabilization] Pascal Suter +563 B 18.03.2018 19:52 tevo_tarantula_i3_3d_printer – [Bed Leveling Sensor] Pascal Suter +79 B 18.03.2018 19:51 tevo_tarantula_i3_3d_printer – [Slicer Software and Settings] Pascal Suter +64 B 18.03.2018 14:45 tevo_tarantula_i3_3d_printer – [X Y Z Axis positions] Pascal Suter ±0 B 18.03.2018 14:45 tevo_tarantula_i3_3d_printer – [Setting the Z Axis Sensor offset] Pascal Suter +102 B 18.03.2018 14:31 tevo_tarantula_i3_3d_printer – [Setting the Z Axis Sensor offset] Pascal Suter +195 B 18.03.2018 14:30 tevo_tarantula_i3_3d_printer – [Setting the Z Axis Sensor offset] Pascal Suter +1.7 KB 18.03.2018 13:25 tevo_tarantula_i3_3d_printer – [X Y Z Axis positions] Pascal Suter -1 B 18.03.2018 13:19 tevo_tarantula_i3_3d_printer – [X Y Z Axis positions] Pascal Suter +1 B 18.03.2018 13:17 tevo_tarantula_i3_3d_printer – [Sensor Offsets] Pascal Suter +1 B 18.03.2018 13:16 tevo_tarantula_i3_3d_printer – [X Y Z Axis positions] Pascal Suter ±0 B 18.03.2018 13:06 tevo_tarantula_i3_3d_printer – [Bed Leveling Sensor] Pascal Suter +44 B 18.03.2018 13:00 tevo_tarantula_i3_3d_printer – [Bed Leveling Sensor] Pascal Suter +556 B Show differences between selected revisionsless recent >> tevo_tarantula_i3_3d_printer.txt Last modified: 23.02.2020 12:03by Pascal Suter