Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| tevo_tarantula_i3_3d_printer [18.03.2018 19:52] – [Bed Leveling Sensor] Pascal Suter | tevo_tarantula_i3_3d_printer [20.03.2018 23:49] – [Z axis stabilization] Pascal Suter | ||
|---|---|---|---|
| Line 49: | Line 49: | ||
| ==== Z axis stabilization ==== | ==== Z axis stabilization ==== | ||
| - | [[https:// | + | one of the structurally weakest point of the Tevo is the off-center Z-axis leadscrew that is hanging by the flex-coupling of the servo.. there are two solutions to this problem, one is to mount the servo at the bottom and then have the Y-axis push down on it, the other is to add a support at the bottom which will hold the weight of the y-axis so that it is not hanging on the flex coupling. |
| + | I decided to go with the support, as it seemed more convenient to implment | ||
| + | [[https:// | ||
| + | [[https:// | ||
| ===== Firmware Setup ===== | ===== Firmware Setup ===== | ||
| Since I have the Auto Level option I had to dig into how to calibrate that thing right away as the auto homing will cause the Z axis to crash into the printing bed with the standard firmware configuration. | Since I have the Auto Level option I had to dig into how to calibrate that thing right away as the auto homing will cause the Z axis to crash into the printing bed with the standard firmware configuration. | ||