Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revisionBoth sides next revision | ||
sonoff [30.11.2020 14:01] – [Falshing Tasmota Firmware] Pascal Suter | sonoff [04.12.2020 19:43] – [Falshing Tasmota Firmware] Pascal Suter | ||
---|---|---|---|
Line 53: | Line 53: | ||
* under " | * under " | ||
* connect your sonoff to the serial2usb adapter WITH MAINS DISCONNECTED!! here is the necessary wiring.. note that rx and tx are crossed over between the two devices. VCC is 3.3V NOT 5V! {{: | * connect your sonoff to the serial2usb adapter WITH MAINS DISCONNECTED!! here is the necessary wiring.. note that rx and tx are crossed over between the two devices. VCC is 3.3V NOT 5V! {{: | ||
+ | * here's the pinout for a shelly1 .. with the shelly1 you need to connect the gpio1 pin to ground whil you power it on in order to get it into flash mode.. {{: | ||
* hold down the push button and plug-in the usb adapter. | * hold down the push button and plug-in the usb adapter. | ||
* let go of the push button and click " | * let go of the push button and click " |