Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
sonoff [30.11.2020 13:58] – [Falshing Tasmota Firmware] Pascal Suter | sonoff [04.12.2020 19:43] – [Falshing Tasmota Firmware] Pascal Suter | ||
---|---|---|---|
Line 47: | Line 47: | ||
here are the steps using Tasmotizer: | here are the steps using Tasmotizer: | ||
- | * install tasmotizer: <code | + | * install tasmotizer: <code> |
pip3 install --upgrade pip wheel | pip3 install --upgrade pip wheel | ||
pip3 install tasmotizer | pip3 install tasmotizer | ||
tasmotizer.py</ | tasmotizer.py</ | ||
* under " | * under " | ||
- | * connect your sonoff to the serial2usb adapter WITH MAINS DISCONNECTED!! hold down the push button and plug-in the usb adapter. | + | * connect your sonoff to the serial2usb adapter WITH MAINS DISCONNECTED!! |
+ | * here's the pinout for a shelly1 .. with the shelly1 you need to connect the gpio1 pin to ground whil you power it on in order to get it into flash mode.. {{: | ||
+ | * hold down the push button and plug-in the usb adapter. | ||
* let go of the push button and click " | * let go of the push button and click " | ||
* click " | * click " |