sonoff

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
sonoff [30.11.2020 13:58] – [Falshing Tasmota Firmware] Pascal Sutersonoff [30.11.2020 14:01] – [Falshing Tasmota Firmware] Pascal Suter
Line 47: Line 47:
  
 here are the steps using Tasmotizer:  here are the steps using Tasmotizer: 
-  * install tasmotizer: <code+  * install tasmotizer: <code>
 pip3 install --upgrade pip wheel pip3 install --upgrade pip wheel
 pip3 install tasmotizer pip3 install tasmotizer
 tasmotizer.py</code> tasmotizer.py</code>
   * under "Select Image" choose "release" and then select whatever image you want to flash, in most cases this will be ''tasmota.bin''    * under "Select Image" choose "release" and then select whatever image you want to flash, in most cases this will be ''tasmota.bin'' 
-  * connect your sonoff to the serial2usb adapter WITH MAINS DISCONNECTED!! hold down the push button and plug-in the usb adapter. +  * connect your sonoff to the serial2usb adapter WITH MAINS DISCONNECTED!! here is the necessary wiring.. note that rx and tx are crossed over between the two devices. VCC is 3.3V NOT 5V! {{:sonoff:pasted_20201130-140133.png}} 
 +  * hold down the push button and plug-in the usb adapter. 
   * let go of the push button and click "refresh" next to the "Select Port" drop down. most likely this will see and select your usb adapter    * let go of the push button and click "refresh" next to the "Select Port" drop down. most likely this will see and select your usb adapter 
   * click "Tasmotize" and wait for it to erase and reflash your device.    * click "Tasmotize" and wait for it to erase and reflash your device. 
  • sonoff.txt
  • Last modified: 07.09.2021 05:52
  • by Pascal Suter