Differences

This shows you the differences between two versions of the page.

--- new_life_for_the_prusa_mk3s_with_klipper [07.01.2026 01:46] – [PID Calibration] Pascal Suter
+++ new_life_for_the_prusa_mk3s_with_klipper [05.02.2026 12:30] (current) – Pascal Suter
@@ Line 1: / Line 1: @@
 ====== new life for the Prusa Mk3S with klipper ======
+**NOTE:** after using the printer with Klipper for a while, i have noticed that its reliablity has gone down, because it no longer has crash detection, a feater I personally find very important. I will revert back to the original Prusa firmware and print speeds for the sake of stability.. I prefer if a long 20 hour Print is reliably done after 20 hours or fails in a recoverable way after 15 or so hours, vs. the print taking only 9 hours but crashing after 8 and leaving me with a huge mess around the extruder and what not to clean up. But of course that's my personal preference.
+===== Klipper on the MK3S =====
 there is a very good [[https://www.youtube.com/watch?v=tamAzV9y1bc&t=355s|video on youtube]] which explains it all. basically a raspberry pi zero w can be added to a prusa mk3s printer and then the klipper firmware can be flashed to control the printer using klipper and therefore enable input shaping which more or less gives you the Mk3.5 upgrade bur for the cost of a raspberry pi zero W and a SD card, roughly 30 CHF in total.