Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| new_life_for_the_prusa_mk3s_with_klipper [05.02.2026 12:29] – [new life for the Prusa Mk3S with klipper] Pascal Suter | new_life_for_the_prusa_mk3s_with_klipper [05.02.2026 12:30] (current) – Pascal Suter | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| **NOTE:** after using the printer with Klipper for a while, i have noticed that its reliablity has gone down, because it no longer has crash detection, a feater I personally find very important. I will revert back to the original Prusa firmware and print speeds for the sake of stability.. I prefer if a long 20 hour Print is reliably done after 20 hours or fails in a recoverable way after 15 or so hours, vs. the print taking only 9 hours but crashing after 8 and leaving me with a huge mess around the extruder and what not to clean up. But of course that's my personal preference. | **NOTE:** after using the printer with Klipper for a while, i have noticed that its reliablity has gone down, because it no longer has crash detection, a feater I personally find very important. I will revert back to the original Prusa firmware and print speeds for the sake of stability.. I prefer if a long 20 hour Print is reliably done after 20 hours or fails in a recoverable way after 15 or so hours, vs. the print taking only 9 hours but crashing after 8 and leaving me with a huge mess around the extruder and what not to clean up. But of course that's my personal preference. | ||
| + | ===== Klipper on the MK3S ===== | ||