how_i_3d_print_-_slicer_settings

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

how_i_3d_print_-_slicer_settings [15.12.2018 16:06] – created Pascal Suterhow_i_3d_print_-_slicer_settings [23.02.2020 12:07] (current) – [PLA] Pascal Suter
Line 12: Line 12:
   * Temperature: Heated bed: Layer 1-3 @ 50°C, 4+ @ 60°C, Extruder: 190°C   * Temperature: Heated bed: Layer 1-3 @ 50°C, 4+ @ 60°C, Extruder: 190°C
   * Cooling - Fan Speeds: Layer 1-2 @ 0%, 3-9 @ 60%, 10+ @ 100% --> this was to prevent warping of the print, combined with the first cold then warmer bed.    * Cooling - Fan Speeds: Layer 1-2 @ 0%, 3-9 @ 60%, 10+ @ 100% --> this was to prevent warping of the print, combined with the first cold then warmer bed. 
 +
 +===== ABS / ASA =====
 +  * The following settins where used for a Layer thickness of 0.4mm 
 +  * Extruder - Retraction: 3mm
 +  * Support: 8% infill, dense infill @ 30%, Max overhang 45°, support pillar resuoltuin: 1mm, 
 +  * Temperature: Heated bed: 110°C, Extruder 260
 +  * Cooling: Fan: off
  • how_i_3d_print_-_slicer_settings.1544886367.txt.gz
  • Last modified: 15.12.2018 16:06
  • by Pascal Suter