Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
tevo_tarantula_i3_3d_printer [18.03.2018 19:51] – [Slicer Software and Settings] Pascal Suter | tevo_tarantula_i3_3d_printer [18.03.2018 19:52] – [Bed Leveling Sensor] Pascal Suter | ||
---|---|---|---|
Line 47: | Line 47: | ||
#define X_MIN_POS 0 | #define X_MIN_POS 0 | ||
#define Y_MIN_POS 42 | #define Y_MIN_POS 42 | ||
+ | |||
+ | ==== Z axis stabilization ==== | ||
+ | [[https:// | ||
+ | |||
===== Firmware Setup ===== | ===== Firmware Setup ===== | ||
Since I have the Auto Level option I had to dig into how to calibrate that thing right away as the auto homing will cause the Z axis to crash into the printing bed with the standard firmware configuration. | Since I have the Auto Level option I had to dig into how to calibrate that thing right away as the auto homing will cause the Z axis to crash into the printing bed with the standard firmware configuration. |