tasmota_on_emil_lux_swiss_wifi_power_plug

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		 Previous revision
Next revisionBoth sides next revision
tasmota_on_emil_lux_swiss_wifi_power_plug [14.10.2022 15:52] – created Pascal Sutertasmota_on_emil_lux_swiss_wifi_power_plug [14.10.2022 17:04] – Pascal Suter
Line 5: Line 5:
  
 Inside the device is a TYWE2S module that is based on an ESP8266 chip, so it's perfect for putting tasmota on it :)  Inside the device is a TYWE2S module that is based on an ESP8266 chip, so it's perfect for putting tasmota on it :) 
 +
 Here is the pinout:  Here is the pinout: 
 +
 {{:tasmota_on_emil_lux_swiss_wifi_power_plug:pasted_20221014-154835.png}} {{:tasmota_on_emil_lux_swiss_wifi_power_plug:pasted_20221014-154835.png}}
  
 +once tasmota is flashed using tasmotizer, go to ''Configuration'' --> ''Configure Other'' and add this string into the **Template** field: 
 +  {"NAME":"Obi CH Plug","GPIO":[1,1,1,1,320,1,1,1,224,576,32,1,1,1],"FLAG":0,"BASE":18}
 +make sure the ''Apply'' checkbox is set and save the changes. Now your plug is fully working, the Red LED will flash while the plug is searching for wifi, the blue LED will come on when the Relay is switched on. So no light means connected wifi but output switched off. 
  
  
  • tasmota_on_emil_lux_swiss_wifi_power_plug.txt
  • Last modified: 14.10.2022 17:16
  • by Pascal Suter