Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
sonoff [10.03.2018 04:39] – [Falshing Tasmota Firmware] Pascal Suter | sonoff [24.07.2018 09:17] – [Making the installation permanent] Pascal Suter | ||
---|---|---|---|
Line 45: | Line 45: | ||
- download the sourcecode tar.gz or zip package from the [[https:// | - download the sourcecode tar.gz or zip package from the [[https:// | ||
- extract the contents of the '' | - extract the contents of the '' | ||
- | - verify your settings under Tools are like these: < | ||
- | Board: " | ||
- | Flash Mode: " | ||
- | Flash Size: "1M (no SPIFFS)" | ||
- | Debug Port: " | ||
- | Debug Level: " | ||
- | LwIP Variant: "v1.4 Prebuilt" | ||
- | Reset Method: " | ||
- | Crystal Frequency: "26 MHz" | ||
- | Flash Frequency: " | ||
- | Upload Using: " | ||
- | CPU Frequency: "80 MHz" | ||
- | Upload Speed: " | ||
- | Port: Your COM port connected to sonoff | ||
- | </ | ||
- edit '' | - edit '' | ||
- **make sure your sonoff is disconnected from the AC power lines*** | - **make sure your sonoff is disconnected from the AC power lines*** | ||
Line 200: | Line 185: | ||
[Unit] | [Unit] | ||
Description=Node.js MQTT DSS Bridge | Description=Node.js MQTT DSS Bridge | ||
- | Requires=After=mosquitto.service | + | Requires=mosquitto.service |
+ | After=mosquitto.service | ||
[Service] | [Service] | ||
Line 226: | Line 212: | ||
[Unit] | [Unit] | ||
Description=Node.js Node-RED | Description=Node.js Node-RED | ||
- | Requires=After=node-red.service | + | Requires=node-red.service |
+ | After=node-red.service | ||
[Service] | [Service] |