This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
| sonoff [25.01.2018 05:39] – [Rules Engine - node-red] Pascal Suter | sonoff [09.02.2018 08:19] – [alternative firmware] Pascal Suter |
|---|
| ===== alternative firmware ===== | ===== alternative firmware ===== |
| * [[https://github.com/arendst/Sonoff-Tasmota|Tasmota]] | * [[https://github.com/arendst/Sonoff-Tasmota|Tasmota]] |
| * works also on some other ESP based devices | * works also on lots of ESP based devices and can be easily adopted to support even more. for example [[MagicHome|MagicHome RGB LED Controllers]] |
| * provides control via serial / web / MQTT | * provides control via serial / web / MQTT |
| ===== What I intend to do with it ===== | ===== What I intend to do with it ===== |
| Debug Port: "Disabled" | Debug Port: "Disabled" |
| Debug Level: "None" | Debug Level: "None" |
| LwIP Variant: "v2 Prebuilt (MSS=536)" | LwIP Variant: "v1.4 Prebuilt" <<<<!!! |
| Reset Method: "ck" | Reset Method: "ck" |
| Crystal Frequency: "26 MHz" | Crystal Frequency: "26 MHz" |
| ===== Future projects ===== | ===== Future projects ===== |
| eventually I'd like to write a script that uses the [[https://github.com/plan44/vdcd|plan44 vdcd]] external device API to integrate a sonoff device into a digitalSTROM setup as an emulated digitalstorm device. this will overcome the lag that is generated by querying the Web-API. we could then also create a dummy light bulb which will just publish its state to MQTT. by assigning it a different value for all of the scenes it is in, we can pass the room-state to MQTT with almost no lag. This will enable other devices like the sonoff to react immediately and not just during the next poll-interval. | eventually I'd like to write a script that uses the [[https://github.com/plan44/vdcd|plan44 vdcd]] external device API to integrate a sonoff device into a digitalSTROM setup as an emulated digitalstorm device. this will overcome the lag that is generated by querying the Web-API. we could then also create a dummy light bulb which will just publish its state to MQTT. by assigning it a different value for all of the scenes it is in, we can pass the room-state to MQTT with almost no lag. This will enable other devices like the sonoff to react immediately and not just during the next poll-interval. |
| | |
| | see my progress on that at [[MQTT for digitalSTROM]] |