Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
workbee_cnc_router [03.11.2019 19:24]
Pascal Suter
workbee_cnc_router [03.11.2019 19:44] (current)
Pascal Suter
Line 52: Line 52:
 |OSB|1/4 upcut|6mm | 19200 | 1700 mm/min | very rough cut, a little smoke every now and then | |OSB|1/4 upcut|6mm | 19200 | 1700 mm/min | very rough cut, a little smoke every now and then |
 |OSB|1/4 upcut|3mm | 19200 | 3000 mm/min | much smoother, no smoke | |OSB|1/4 upcut|3mm | 19200 | 3000 mm/min | much smoother, no smoke |
 +
 +next: mdf: so far huge defelction of machine at any speed that does not create smoke or even if it is slow enough to cause lots of smoke. found out that the machine'​s Z axis suddenly had lots of play, need to readjust the wheels and also clean out the bit.