Differences
This shows you the differences between two versions of the page.
Next revisionBoth sides next revision | |||
workbee_cnc_router [03.11.2019 17:52] – created Pascal Suter | workbee_cnc_router [03.11.2019 19:24] – Pascal Suter | ||
---|---|---|---|
Line 37: | Line 37: | ||
$110 = 4000.000 | $110 = 4000.000 | ||
$111 = 4000.000 | $111 = 4000.000 | ||
- | $112 = 2000.000 (Z-axis maximum rate, mm/min) | + | $112 = 500.000 (Z-axis maximum rate, mm/min) |
$120 = 300.000 | $120 = 300.000 | ||
$121 = 300.000 | $121 = 300.000 | ||
Line 45: | Line 45: | ||
$132 = 200.000 | $132 = 200.000 | ||
</ | </ | ||
+ | |||
+ | the above maximum speeds where reached doing aircuts only! | ||
+ | |||
+ | Here are some configurations that worked so far: | ||
+ | ^material^bit^depth^spindle RPM^feed rate (mm/min)^ result ^ | ||
+ | |OSB|1/4 upcut|6mm | 19200 | 1700 mm/min | very rough cut, a little smoke every now and then | | ||
+ | |OSB|1/4 upcut|3mm | 19200 | 3000 mm/min | much smoother, no smoke | | ||
+ |