Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revisionBoth sides next revision | ||
| triple_head_with_two_nvidia_cards_for_dualhead_twinview_main_screen_and_separate_status_display [02.02.2016 19:33] – Pascal Suter | triple_head_with_two_nvidia_cards_for_dualhead_twinview_main_screen_and_separate_status_display [02.02.2016 19:35] – Pascal Suter | ||
|---|---|---|---|
| Line 53: | Line 53: | ||
| - you should now be able to move your mouse over the side of your desktop that you selected in the previous command (in this example it is the right side) and straight into the satatus display screen. there you can do whatever setup you want for your status display. | - you should now be able to move your mouse over the side of your desktop that you selected in the previous command (in this example it is the right side) and straight into the satatus display screen. there you can do whatever setup you want for your status display. | ||
| - it is up to you if you want to enable x2vnc only on demand or if you want it to be enabled whenever you are logged in.. if it should always be enabled ad the respective entry in the " | - it is up to you if you want to enable x2vnc only on demand or if you want it to be enabled whenever you are logged in.. if it should always be enabled ad the respective entry in the " | ||
| + | |||
| + | ===== How i did it a few years later :) ===== | ||
| + | I recently got two new screens for my main display which lead to a new GPU as well, since my old nvidias didn't support the screens resolution. newer graphics cards often come with more than two outputs like my GeForce 750 with 2 DVI, 1 HDMI and 1 VGA port. I now connected the two main displays to the two DVI ports, and the old 19" display i still use as a status screen ot the VGA port. since i had some difficutlties in getting the 2-seat setup to work again on a single card i realized it is actually much simpler to just configure the card to run with two x-displays, one featuring the two main screens and the second display runs on the 19" status monitor. upon startup i start firefox with its own profile on the second display and it opens in full screen mode and shows my status display. it all looks like before, it is just a lot simpler to set up. and i must admit, i think this setup could also be possible with two separate cards installed, so you might want to try that first before following my steps below. | ||
| + | |||
| + | to start firefox on the second display i simply run: | ||
| + | DISPLAY=: | ||
| + | |||
| + | what's cool thoug about the 2 seat solution described above is, that you can regulate the settings (like screen saver, stand by etc.) completely autonomous for the status monitor and it even shows the status screen when the main screen is locked.. so this might still be a better solution for some situations.. for example when the status display is seen by more than just the user of the main screens. | ||
| + | |||