Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revisionBoth sides next revision | ||
| tevo_tarantula_i3_3d_printer [16.02.2020 23:14] – [Slicer Software and Settings] Pascal Suter | tevo_tarantula_i3_3d_printer [16.02.2020 23:14] – [Dead Stepper driver - workaround] Pascal Suter | ||
|---|---|---|---|
| Line 146: | Line 146: | ||
| </ | </ | ||
| i then re-compiled and uploaded the firmware and could print right away. | i then re-compiled and uploaded the firmware and could print right away. | ||
| + | |||
| + | of course i've also trimmed the bracket :) | ||