Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
tevo_tarantula_i3_3d_printer [09.12.2018 17:11] – [Settings] Pascal Suter | tevo_tarantula_i3_3d_printer [15.12.2018 15:56] – [Slicer Software and Settings] Pascal Suter | ||
---|---|---|---|
Line 119: | Line 119: | ||
===== Slicer Software and Settings ===== | ===== Slicer Software and Settings ===== | ||
- | Whatever software you are using, make sure that the Start GCode contains G28 and G29 for auto hight and auto bed leveling. | + | Whatever software you are using, make sure that the Start GCode contains G28 and G29 for auto height |
+ | for more detailed settings see [[How I 3d Print - Slicer settings]] |