Differences
This shows you the differences between two versions of the page.
tasmota_on_the_jr-tm05s_water_supply_timer [14.08.2020 02:20] – created Pascal Suter | tasmota_on_the_jr-tm05s_water_supply_timer [16.08.2020 21:55] (current) – Pascal Suter | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Tasmota JR-TM05S Water Supply Timer ====== | + | ====== Tasmota |
I recently bought a wifi enabled water supply timer [[https:// | I recently bought a wifi enabled water supply timer [[https:// | ||
Line 39: | Line 39: | ||
open a web browser and enter http:// | open a web browser and enter http:// | ||
- | and there you go.. even the gpio pre-config seems to work right away, the button still opens and closes the valve and the toggle button on the web interface does the same :) | + | and there you go.. even the gpio pre-config seems to work right away, the button still opens and closes the valve and the toggle button on the web interface does the same :) |
+ | |||
+ | for the re-assebly i put the board back into the case and then sealed it again with some electronics-silicone. I sealed it so that the 4 pins would still stick out the back. After the silicon had dried, i bent the 4 pins 90° as otherwise the valve would not fit into the housing anymore. but by bending the pins that was taken care of, and they still remain accesible should i ever need them again |