no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Last revision | |||
— | how_i_3d_print_-_slicer_settings [15.12.2018 16:06] – created Pascal Suter | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== How I 3d Print - Slicer settings ====== | ||
+ | this is ment to be more some kind of a collection of settings that have worked for me in the past. I use this because i don't use my 3d printer on a daily basis but instead have rather long pauses between usage periods. So I tend to forget what worked the last time and then have to start from scratch again: | ||
+ | All the settings below are for printing on a Tevo Tarantula 3D Printer using Simplify 3d as my slicer software. I will note the changes from the defaults in Simplify 3d. | ||
+ | |||
+ | ===== Printbed setup ===== | ||
+ | I have put a 21x21cm sized piece of glass (actually cut out of some scrap of a spy mirror) on top of the heated bed and spray just a little bit of hairspray on top of it to make it matte, this seems to help adhesion well enough and can be cleaned off with some water. | ||
+ | |||
+ | ===== PLA ===== | ||
+ | * Extruder - Retraction: 3mm (1 is default but leads to " | ||
+ | * Support: 10% infill with 4mm offset worked fine for a 1.5x6.5cm area. | ||
+ | * Temperature: | ||
+ | * Cooling - Fan Speeds: Layer 1-2 @ 0%, 3-9 @ 60%, 10+ @ 100% --> this was to prevent warping of the print, combined with the first cold then warmer bed. |