Differences
This shows you the differences between two versions of the page.
creality_cr-10_v2_3d_printer [23.04.2020 00:00] – created Pascal Suter | creality_cr-10_v2_3d_printer [23.04.2020 00:20] (current) – [Octoprint] Pascal Suter | ||
---|---|---|---|
Line 15: | Line 15: | ||
for cura, there is an ocotprint plugin that needs to be installed first, after that it can be configured using the api key and once this is done, you can print directly out of cura as well. | for cura, there is an ocotprint plugin that needs to be installed first, after that it can be configured using the api key and once this is done, you can print directly out of cura as well. | ||
+ | |||
+ | ====== spool holder ====== | ||
+ | the spool holder on the external power supply and controller box is just hidious.. actually the entire box is, but the spoolholder makes it worse because the box does not have rubber feet and if the filamet overlaps slightly on the spool it starts pulling the controller to the printer and create all sorts of troubles. | ||
+ | |||
+ | there is a very simple solution to that: mount the spool holder on top of the printer, prusa style. i've downloaded and printed [[https:// | ||
+ | |||
+ | ====== controller and power supply housing ====== | ||
+ | i haven' | ||